![]() On the left it is indicated in square brackets with a negative sign "" the services that are stopped are, with a positive sign "" running services, and with a question mark "" I am not entirely clear, but they may be special cases in which Systemd cannot correctly detect their status, but in my opinion these may be running or stopped. An example of the output is as follows: sudo service -status-all This is undoubtedly one of my favorite arguments, since it lists all the services installed in our distribution, in addition to indicating whether they are running or not. List of all services and their current status sudo service -status-all Services normally run automatically at system startup, so if we stop a service it is only temporary and will start again at the next startup as long as it doesn't have any problems.ĥ. ![]() Stop a service temporarily with "stop" sudo service postfix stop The configuration reload can be useful when only the configuration that manages the service has changed, as long as it supports it, since in the case of "restart", with "reload" it is avoided to completely stop the service and then start it. Reload service configuration with "reload" sudo service postfix reload With this command we can check if Apache2 is running or if it has a problem. Check current status of a service with "status" sudo service apache2 status In this case, we restart the Nginx service. 2 Answers Sorted by: 0 sudo systemctl -typeservice sudo systemctl -stateactive sudo systemctl -statefailed journalctl -b -p err These should be enough to monitor and to find any misbehaving services. Restart services using the "restart" argument sudo service nginx restart If we try to handle a service that does exist with an argument that does not exist, we will obtain a list with all the arguments available for that service, since each service handles different state arguments. If a service does not exist, the command indicates it with an error similar to "Failed to start abc.service: Unit abc.service not found.". This format will apply to all the arguments mentioned at the beginning. The format is the command "service", followed by the name of the service, and then the argument that manages the state of the service. ![]() List of all services and their current status.Reload service configuration with "reload".Check current status of a service with "status". ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |